CH-1.2 CD Carbon Stabilizer

Attention). It may be unable to be used by the model of CD deck. Please set CD software of two to CD deck. And please check that CD deck operates. If it operates, this CD stabilizer can be used.

CH-7 7t Carbon Head Shell

This head shell is made from the ultra particle carbon that is spent on the motor brush of the Shinkansen. This head shell fully absorbs the vibration that received from the needle tip of a cartridge. As a result, an unnecessary vibration does not return the needle tip of a cartridge and the sound of a record is reproduced faithfully. However, the type (a single knife edge, one point support) that the shaft of tone arm shakes cannot be removed the distortion of mid-high-sound by the vice of tone arm.

Weight 16g

CH-10 Carbon Turntable Mat

"This Sheet will upgrade your record players by several times." This turntable mat is manufactured by cutting, machining and surface lapping high-purity carbon block, which is obtained by subjecting the materials (mainly consisting of petroleum coke) to three processes of high pressure treatment, high temperature furnace treatment and calcinations for about three months.
Since the fine carbon particles in this sheet are spherical, and thus, capable of diffusing and absorbing vibration waves, this sheet is capable of absorbing any vibration between the surfaces of a disk and a turntable smoothly without returning irregular vibration to the desk.
Therefore, in all band widths of low, middle and high, music sound recorded in the desk will be reproduced in an ideally natural manner (in terms of transparency, sound source localization and definition).
Since energy loss is smaller than that of ordinary turntables, the reproduced music will be free from vagueness, distortion and dullness, bringing to you 20 to 30% higher auditory power and the feel of larger scale.
Provision of chamois leather sheet for better matching between the disk and the carbon sheet will be most effective.
Attention). This mat is not recessed at the area corresponding to the labeled area of the disk. We think this recess is meaningless since JIS Standard of disk allow a dimensional tolerance of 1.5 to 2.3 mm for the thickness at the labeled area.

A chamois leather sheet helps to solve such problem as well.

Outer Dia : 297mm Thickness : 10mm Weight : 1.0Kg

LTP-11 LTP-11 Carbon Disk Clamp

" Made of material for motor brushes of Shinkansen bullet train"
This disk clamp is manufactured of super fine particle carbon used for motor brushes of Shinkansen bullet train by cutting, machining this material, and then, providing special polishing treatment to be surface of it. Since the carbon particles in this material are spherical in shape, this clam is capable of diffusing and absorbing the vibration on the surface of a disk and a turntable in a smooth point.
Therefore, in all band widths of low, middle and high, nature of the music (atmosphere of the original sound) recorded into the disk will be reproduced in an idealistic beauty (in terms of transparency, sound source localization and distortion).
While high-pitched sound from a record player with an ordinary disk clamp tends to become dull or distorted, a record player provided with this carbon clamp will reproduce entire range of sound from low-pitched sound to high-pitched sound.
Therefore, you can enjoy refreshing, creamy and smooth sound with beautiful reverberations reproduced closer to the original sound.

Attention). A heavy record clamp becomes the sound which had the throat bound tight, and can be heard stuffily.

Weight 255g